Bosch Zamo Original Instructions Manual page 39

Digital laser measure with wheel
adapter
Operation
– Switch on the measuring tool (see "Switching the laser
measure on/off", page 33).
Length measurement (see figures K1−K2).
– Run the wheel (15) along the distance to be measured.
After the measuring tool has been switched on, the wheel
measures continuously. The current measured value (g) is
shown on the bottom line of the display.
During continuous measurement, the wheel can be moved
forwards or backwards. The measured values will be posit-
ive in both directions. If the direction is changed during the
measurement, the value will be deducted until the starting
point (zero point) has been reached. Once the starting
point has been crossed, the value will become positive
again.
The current measured value (g) is updated on the bottom
line of the display.
– The measuring process ends once the wheel has come to a
stop. The current measured value (g) is shown.
– Press the measuring button (1) again to save the measured
value, and continue measuring. The current measured value
(g) is shown on the bottom line of the display, while the
previous measured value (e) is displayed above it.
Note: In order to obtain an exact measurement, do not change
the angle between the measuring tool and the surface (see fig-
ure L). Make sure that you apply a steady amount of pressure
throughout the measuring process. The result may vary on soft
substrates and/or when applying excessive pressure. The re-
commended pressure for an exact measurement result is equi-
valent to 500 g.
Bosch Power Tools
English | 39
1 609 92A 7L5 | (05.05.2022)