Bosch Zamo Original Instructions Manual page 37

Note: If the measuring tool is switched on when fitting the ad-
apter, the laser will automatically switch off. Pressing the
measuring button (1) will reactivate the laser line.
Aligning the laser line
– Align the laser line with the level for horizontal alignment
(12) (see figure F) or the level for vertical alignment (11)
(rotate the measuring tool by 90°) (see figure G).
The bubble must be in the centre of the level vial.
– To precisely align the laser line, you can turn the adapter
head by ±10° around the laser line.
Note: Make sure that the measuring tool is always positioned
horizontally in order to obtain an exact measurement. You can
adjust the height of the laser line by placing suitable objects
underneath (e.g. a ladder, books, etc.).
Digital laser measure with tape
adapter
Operation
– Switch on the measuring tool (see "Switching the laser
measure on/off", page 33).
Only use the tape adapter on clean and dust-free sur-
u
faces to avoid measurement inaccuracies.
Measuring length (see figures I1−I2)
After the measuring tool has been switched on, the tape exten-
sion is measured continuously. The current measured value
(g) is shown on the bottom line of the display. During continu-
ous measurement, the length of the tape can be adjusted, and
the current measured value (g) is updated on the bottom line
of the display.
The measuring process is indicated by a rolling arrow on the
display.
Bosch Power Tools
English | 37
1 609 92A 7L5 | (05.05.2022)