Newco Bistro Touch BISTRO-TCH Operating Instructions Manual page 28

Cleaning Instructions
1. Remove the product BIBs from the machine and connect a
BIB of cleaning solution to the PUMP 1 (COFFEE) BIB
connector as shown in figs. 1-4 page 27.
2. Enter Cleaning and Priming Menu (Page 14)
3. Press the Clean Pumps button on the display panel to enter
Cleaning Mode.
4. Display message will read "Connect Cleaning Solution to Bib
Connector".
5. Place an empty 12 oz cup in the dispense area. Press "Clean
Coffee Pump" button to Start- Cleaning Cycle will start and
finish automatically.
6. Cleaning cycle runs 2.5 minutes total: pump 45 sec., dwell 90
sec., & water 15 sec
7. When cleaning cycle ends, disconnect the BIB of cleaning
solution from the Pump BIB connector and replace the coffee
BIB with new product. The machine will automatically advance
to the Prime Pumps mode.
8. To Prime: Press and hold the "Prime Coffee Pump"" button
until a steady stream of product flows from the dispense area
into the vessel.
9. Change Cleaning solution to Pump 2 (DECAF) and repeat
steps 3-8 to Clean and Prime Pump 2 (DECAF).
10. Exit to Home screen
11. Discard the Contents of the 12 oz cup.
when finished.
28