Sensor Board - HP 11-be0 Series Maintenance And Service Manual

1. Prepare the computer for disassembly (see
2. Remove the display assembly (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Disconnect the two speaker cables from the system board (1).
2. Remove the speaker cables from their routing around the left and top of the computer (2).
3. Remove the two Phillips M2.0 × 2.0 screws (3) that secure each speaker to the computer. The computer
includes three speakers.
4. Remove the speakers and cables from the computer (4).
Reverse this procedure to install the speakers. Run the camera function test after the repair. For more
information, see

Sensor board

To remove the sensor board, use this procedure and illustration.
Table 5-5 Sensor board description and part number
Description
Sensor board, DF
Sensor board, FF
Sensor board cable
Before removing the sensor board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display assembly (see
3. Disconnect the battery cable from the system board (see
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
Display assembly on page
Basic camera function test on page
Display assembly on page
Preparation for disassembly on page
30).
Battery on page
30.
Preparation for disassembly on page
30).
Battery on page
29).
44).
Spare part number
M93500-001
M99727-001
M98508-001
29).
44).