Sensor Board - HP Pro Slate 10 EE G1 Maintenance And Service Manual

14. Detach the WLAN auxiliary antenna transceiver (2) from the display panel assembly. (The WLAN
auxiliary antenna transceiver is attached to the display panel assembly with double-sided adhesive.)
15. Remove the WLAN auxiliary antenna cable and transceiver.
Reverse this procedure to install the wireless antennas.

Sensor board

Description
Sensor board (includes cable and double-sided adhesive)
Before removing the sensor board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Disconnect the battery cable from the system board (see
Remove the sensor board:
32 Chapter 5 Removal and replacement procedures
Back cover on page 23).
Spare part number
802828-001
Battery on page 24).