Daily Safety Checks - Triumph Street Triple S Owner's Handbook Manual

Daily Safety Checks

Warning
Failure to perform these checks every
day before you ride may result in
serious motorcycle damage or an
accident causing serious injury or
death.
Check the following items each day
before you ride. The time required is
minimal, and these checks will help
ensure a safe, reliable ride.
If any irregularities are found during
these checks, refer to the Maintenance
and Adjustment section or see your
authorised Triumph dealer for the action
required to return the motorcycle to a
safe operating condition.
Check the following:
Fuel: Adequate supply in tank, no fuel
leaks (page 105).
Engine Oil: Correct level on dipstick. Add
correct specification oil as required. No
leaks from the engine or oil cooler
(page 146).
Drive Chain: Correct
(page 156).
Tyres/Wheels:
pressures (when cold). Tread depth/
wear, tyre/wheel damage, punctures
etc. (page 180).
Nuts, Bolts, Fasteners: Visually check
that steering
components, axles, and all controls are
properly tightened or fastened. Inspect
all areas for loose/damaged fixings.
adjustment
Correct inflation
and suspension
GENERAL INFORMATION
Steering Action: Smooth but not loose
from lock to lock. No binding of any of
the control cables (page 168).
Brakes: Pull the brake lever and push
the brake pedal to check for correct
resistance. Investigate any lever/pedal
where the travel is excessive before
meeting resistance, or if either control
feels spongy in operation (page 160).
Front Brake Pads: Check that the
correct amount of friction material is
remaining on all
(page 160).
Brake Fluid Levels: No brake fluid
leakage. Brake fluid levels must be
between the MAX and MIN marks on
both reservoirs (page 163).
Front Forks: Smooth action. No leaks
from fork seals (page 170).
Throttle: Make sure that the throttle
grip returns to the idle position without
sticking (page 26).
Clutch: Smooth operation and correct
cable free play (page 154).
Coolant: No coolant leakage. Check the
coolant level in the expansion tank
(when the engine is cold) (page 151).
Electrical Equipment: All lights and the
horn function correctly (page 191).
Engine Stop: Stop switch turns the
engine off (page 122).
Stand: Returns to the fully up position
by spring tension. Return springs not
weak or damaged (page 113).
the brake pads
119