Front Operator Panel - Lenovo ThinkSystem SR860 Setup Manual

This panel contains controls and LEDs that provide information about the status of the server.
11 Rack release latches:
Press the latch on both sides in the front of the server to remove the server out of the rack.
12 2.5-inch drive bays:
Install 2.5-inch drives to these bays. See

Front operator panel

The following illustration shows the controls and LEDs on the front operator panel.
Figure 6. Front operator panel
Table 4. Buttons and LEDs on the front operator panel
Power button/LED (green)
1
Network activity LED (green)
2
1 Power button/LED (green)
Press this button to turn the server on and off manually. The states of the power LED are as follows:
Off: No power supply is properly installed, or the LED itself has failed.
Flashing rapidly (4 times per second): The server is turned off and is not ready to be turned on. The
power-control button is disabled. This will last approximately 5 to 10 seconds.
Flashing slowly (once per second): The server is turned off and is ready to be turned on. You can press
the power-control button to turn on the server.
Solid on: The server is turned on.
2 Network activity LED (green)
When this LED is lit, it indicates that the server is transmitting to or receiving signals from the Ethernet LAN.
3 Identification button/LED (blue)
Use this blue LED to visually locate the server among other servers. This LED is also used as a presence
detection button. You can use Lenovo XClarity Administrator to light this LED remotely.
4 System error LED (yellow)
When this yellow LED is lit, it indicates that a system error has occurred. This LED can be controlled by the
Lenovo XClarity Administrator. Information provided from the LCD display of the front operator panel could
also help isolate an error.
ThinkSystem SR860 Setup Guide
16
"Install a 2.5-inch hot-swap drive" on page 107
Identification button/LED (blue)
3
System error LED (yellow)
4
for more details.