Install The Security Bezel - Lenovo ThinkSystem SR860 Setup Manual

After installing the top cover, complete the following steps:
1. Reconnect the power cords and any cables that you removed.
2. If the server is installed in a rack, reinstall the server into the rack.
3. Power on the server and any peripheral devices.

Install the security bezel

Use this procedure to install the security bezel.
Before installing the security bezel:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. If you have removed the rack handles, reinstall it (see ThinkSystem SR860 Rack Installation Guide).
To install the security bezel, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
Step 1. Carefully insert the tabs on the security bezel into the slots on the right rack handle. Then, press
and hold the release latch, and pivot the security bezel inward until the other side clicks into place.
Figure 95. Security bezel installation
Release latch
1
Step 2. Use the key to lock the security bezel to the closed position.
ThinkSystem SR860 Setup Guide
130
56).
.
"Safety" on page iii
https://www.youtube.com/watch?v=pIb0bIyfkDY&=
and "Installation