Lenovo ThinkSystem SR860 Setup Manual page 156

3. After you have Lenovo XClarity Essentials OneCLI in place, type the following command to set the
DMI:
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> [access_method]
Where:
<asset_tag>
The server asset tag number. Type asset aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa, where
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the asset tag number.
[access_method]
The access method that you select to use from the following methods:
– Online authenticated LAN access, type the command:
[--bmc-username xcc_user_id --bmc-password xcc_password]
Where:
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts).
Example command is as follows:
tag> ––bmc-username xcc_user_id
––bmc-password xcc_password
– Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example command is as follows:
tag>
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
– Remote LAN access, type the command:
Where:
xcc_external_ip
The BMC/IMM/XCC IP address. There is no default value. This parameter is required.
xcc_user_id
The BMC/IMM/XCC account (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts).
Note: BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are all
valid for this command.
Example command is as follows:
tag>
––bmc xcc_user_id:xcc_password@xcc_external_ip
4. Reset the Lenovo XClarity Controller to the factory defaults. See "Resetting the BMC to Factory
Default" section in the XCC documentation compatible with your server at
sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html
ThinkSystem SR860 Setup Guide
148
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_
[––bmc xcc_user_id:xcc_password@xcc_external_ip]
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_
https://
.