Product Insert English (Original) - YASKAWA iC9200 Series Manual

Product insert English (original)

Product insert English (original)
Product: CPU iC9210-PN (Order no. PMC9210P0)
n The product CPU iC9210-PN is a CPU with a PROFINET controller and belongs to the iC9200 Series for programming in
IEC 61131-3 language.
Associated documentation
Before using the device, be sure to read the hardware manual HB700_CPU_ PMC9210P0 for CPU iC9210-PN, valid for
n
the hardware respectively firmware version specified on the device. Please also consider the other documents mentioned.
n Ensure that you always use the most recent documentation. You can find these in the service area of
www.yaskawa.eu.com .
DANGER!
Safety instructions
Observe the following safety instructions! Disregarding these safety regulations may result in death, serious personal
injury or damage to equipment.
– Personal and property protection are only guaranteed if the device is used in accordance with its intended use.
– Observe the safety regulations of electrical engineering and the employer's liability insurance association!
– Only perform work on the device when the power is switched off!
– The device may only be installed by qualified personnel in accordance with the specifications in the corresponding
documentation.
– Electrical work may only be performed by qualified electricians.
– The device may only be commissioned by a person responsible for the safety of the system. Only this person may
connect the supply voltage.
– Observe the necessary precautions when handling electrostatically sensitive components (EN 61340-5-1, IEC
61340-5-1)!
– Repairs to the device, particularly the opening of the housing, must only be performed by the manufacturer.
– Keep the operating instructions!
– The operator of the device or plant is subject to the legal obligations regarding safety at work. The Machinery
Directive must therefore be taken into account.
Intended use
WARNING!
Danger by non intended use!
Any other use beyond the intended use and / or other use of this product can lead to dangerous situations and is pro-
hibited.
The CPU iC9210-PN is designed and produced for:
industrial use.
n
n general control and automation solutions.
industrial network communication, machine and process control.
n
the connection to PROFINET.
n
n the installation in a control cabinet with degree of protection IP54 or better.
operation within the environmental conditions specified in the technical data.
n
Electrical safety - loss of safety function when using unsuitable power supplies
n Only devices with safe insulation from the 230 V mains may be connected to the device. The power supply for generating
the 24 V power must correspond to the requirements for PELV/SELV according to EN 50178.
Protection against direct and indirect contact must be guaranteed for all components connected to PROFINET. In the
n
event of a fault, parasitic voltages must not occur (single fault security).
Licensing information for open source software
This device uses open source software.
n
n Further information on the open source licenses can be found in the hardware manual HB700_CPU_ PMC9210P0.
PROFINET installation guideline
When working on PROFINET and its components, the PROFINET installation guideline must always be available and
n
must be strictly observed. This document can be found on the PI Organization web site (Profibus & Profinet International).
2 CPU iC9210-PN - PI | Rev. 22-04