Central Heating Heating Circuit Selection - Viessmann VITODENS Operating Instructions Manual

Central heating
Heating circuit selection
If required, the heating of your rooms can be split over
several heating circuits.
At the factory, heating circuits are designated 1, 2, 3 in
the header.
■ If you are controlling several heating circuits, for all
central heating settings, first select the heating circuit
to which the change should apply.
■ If you are only controlling one heating circuit, this
option is not available.
Room temperature
Further information can be found in chapter
"Terminology" in the appendix.
Setting the standard room temperature for the selected heating circuit
Factory setting: 20 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Heating circuit 1 2 3" in the header to select the
required heating circuit
Setting reduced room temperature
Factory setting: 3 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Menu"
2. "Heating"
3. "Heating circuit 1 2 3" for the required heating cir-
cuit
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
24
Tap repeatedly on "Heating circuit 1 2 3" until the
required heating circuit is active.
Fig. 15
2. / for the required value
3. OK to confirm
4. "Reduced room temperature"
5.
/ for the required value
6. OK to confirm
Central heating with this temperature:
■ Between the time phases for central heating with
standard temperature
In the holiday program
■