Operating Principles; Screen Displays; Buttons - Viessmann VITODENS 100-W B1HE Operating Instructions Manual

Vitodens 100-W B1HE/B1KE Operating

Operating Principles

Display
You can adjust any setting on your system centrally at
the control unit.
The control unit is equipped with a black/white screen.
For settings and to call up information, tap the on screen

buttons.

Room temperature controller for room temperature-
dependent operation
If a room temperature controller is installed in one of
your rooms, you can adjust some settings at your room
temperature controller.
Operating instructions for room temperature
controller

Screen Displays

Buttons
Calls up the main menu.
Takes you one step back.
To select a menu or adjust values.
OK Confirms your selection or saves the setting made.
Status display with Lightguide
A red illuminated strip (Lightguide) is displayed at the
lower or upper edge of the control unit during operation.
Meaning of the display:
Lightguide pulsates slowly:
Display is in standby mode.
Lightguide is illuminated constantly:
You are operating the control unit. Every input
operation is confirmed by a brief flashing.
Lightguide flashes quickly:
There is a fault in the system.
Note: You can switch off the Lightguide. See page 19.
Standby
The display backlighting is switched off after approximately
2 minutes.
Home screen
After starting or activating the control unit the home
screen is shown.
The home screen shows information about the DHW.
Call up the home screen as follows:
Standby is active: Tap any button.
From anywhere in the menu:
Tap repeatedly, until the home screen is displayed.
Special key combinations:
Direct to system overview from a menu:
press and hold for approx. 4 sec.
Establishing internet connection:
In the home screen, press and hold OK for approx. 4 sec.
Switching WiFi on and off:
+OK: Press and hold simultaneously for approx. 4 sec.
Calling up burner status:
+ : Press and hold simultaneously for approx.
4 sec.
Operation
11