Table of Contents
Advertisement
(1) Using the Oscillator Circuit on the Target System
When turning on the power supply, the internal clock of emulation pod is selected to supply the clock
to the MCU. To use the external clock on the target system, change the clock by the Init dialog when
starting up the emulator debugger or the CLK command on the script window. (For details, refer to
the user's manual (or online manual) of the emulator debugger)
Figure 3.4 External oscillator circuit
Figure 3.5 Circuit in which oscillation does not occur (same for X
Notes on External Clock:
• To operate the emulation pod with an external clock, construct the oscillator circuit
as shown in Figure 3.4 in the target system and input the oscillator output at 50% duty
(within the operating range of the evaluation MCU) into the X
pin should be open.
• Make note of the fact that in the oscillator circuit shown in Figure 3.5 where a
resonator is connected between the X
because a flexible cable, buffer IC and other devices are used between the evaluation
MCU and the target system. It is same for sub-clock oscillator circuits (X
X
).
COUT
IMPORTANT
and X
IN
( 36 / 76 )
-X
)
CIN
COUT
pin. And the X
IN
pins, oscillation does not occur
OUT
OUT
and
CIN
Advertisement
Table of Contents
