Renesas Emulation Pod M306H2T-RPD-E User Manual page 34

Table 3.3 Switch settings of the M306H2T-RPD-E (3/4)
Switch Signal
SW6 SYNCIN
SW7 Unused
SW8 Unused
SW9 CVIN1
SW10 Unused
Jumper switch setting
SYNC/HOR
JC1
Connects the SYNCIN pin to the
RCA connector JC1 on the M306H0T-
PRT. (Factory-setting)
JC2
Only this setting is available.
(Factory-setting)
JC3
Only this setting is available.
(Factory-setting)
CVIN1
JC4
Connects the CVIN1 pin to the RCA
connector JC4 on the M306H0T-
PRT. (Factory-setting)
JC5
Only this setting is available.
(Factory-setting)
( 32 / 76 )
SYNC/HOR
FLX JC1
Connects the SYNCIN pin to the
target system via the FLX160.
FLX JC2
Do not use this setting.
FLX JC3
Do not use this setting.
CVIN1
FLX JC4
Connects the CVIN1 pin to the target
system via the FLX160.
FLX
JC5
Do not use this setting.
FLX
FLX
FLX
FLX
FLX