Set Minimum Calibration And Validation Values (Min); Set Maximum Calibration And Validation Values (Max); Set Oven And Calibrator Delays (Delay) - Scanivalve MPS4232 Hardware And Software Manual

MPS4232

Set Minimum Calibration and Validation Values (MIN)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
EXAMPLE
DEFAULT
RANGE

Set Maximum Calibration and Validation Values (MAX)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
EXAMPLE
DEFAULT
RANGE

Set Oven and Calibrator Delays (DELAY)

COMMAND
TYPE
DESCRIPTION
SYNTAX
MIN
Set/Get
Sets the minimum calibration and validation temperature and pressure.
SET MIN <tcal> <pcal> <tval> <pval>
Where:
<tcal> = Minimum temperature value for a calibration.
<pcal> = Minimum pressure value for a calibration.
<tval> = Minimum temperature value for a validation.
<pval> = Minimum pressure value for a validation.
Prompt when ready to accept a new command
SET MIN 0 -5.5 10 -5.0
>
0 -15 0 -15
These values are not range checked.
MAX
Set/Get
Sets the maximum calibration and validation temperature and pressure.
SET MAX <tcal> <pcal> <tval> <pval>
Where:
<tcal> = Maximum temperature value for a calibration.
<pcal> = Maximum pressure value for a calibration.
<tval> = Maximum temperature value for a validation.
<pval> = Maximum pressure value for a validation.
Prompt when ready to accept a new command
SET MAX 70 5.5 60 5.0
>
70 15 70 15
These values are not range checked.
DELAY
Set/Get
Sets the delay in minutes and seconds for the oven and calibrator, respectively.
SET DELAY <iodelay> <odelay> <cdelay> <spcdelay>
Where:
<iodelay> = Initial oven delay in minutes.
<odelay> = Oven delay in minutes. Setting this value to zero enables a stable query to the MPS
(MPS must be +/-0.125°C for 10 minutes, 120 minute timeout).
<cdelay> = Calibrator delay in seconds. Setting this value to zero uses the calibrator's STABLE
command.
<spcdelay> = Special Delay in seconds. This dwell is between the time between the positive
applied points, and the negative applied points.
63
Section 5: Software