Fault Finding; Technical Data; Disposing Of The Product - Grundfos CIM 060 Installation And Operating Instructions Manual

Communication interface module
Table of Contents

Advertisement

6. Fault finding

Fault
The connection between
the Grundfos GO and the
CIM 060 has failed.
No internal communication
between the CIM 060 and
the product. (LED flashing
red).
See also installation and operating instructions of the product in question and of the Grundfos GO.
The above manuals can be found in the Grundfos Product Center: product-selection.grundfos.com
Related information
5.1 Via the connection button

7. Technical data

Communication range
of on-board antenna
Storage temperature
Operating temperature
Operating and storage
humidity
External antenna
Possible cause
Power is off.
The product has no connection code
or has a different connection code.
The connection time has elapsed (30
seconds).
The CIM 060 is defective.
The CIM 060 is not fitted correctly on
the product.
The connecting plug on the CIM 060
is defective.
The connecting plug on the product
is defective.
10 m
-20 to 85 °C
-20 to 85 °C
0-95 % RH
Non-condensing
2.4 GHz RF signal
SMA connector
Max. cable length 2.9 m
Remedy
Turn power on. Wait until the LED ceases
to flash.
Connect via the connection button on the
module. See Via the connection button.
Reselect the product in Grundfos GO.
Note: If the connection button has not
been pressed within 30 seconds from the
time the product was selected in Grundfos
GO, the connection is cancelled.
Replace the CIM 060.
Check that the module is fitted correctly.
Check the connecting plug on the CIM 060
(one of the pins might be damaged).
Check the connecting plug on the product.

8. Disposing of the product

This product or parts of it must be disposed of in an
environmentally sound way.
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The crossed-out wheelie bin symbol
on a product means that it must be
disposed of separately from household
waste. When a product marked with
this symbol reaches its end of life, take
it to a collection point designated by
the local waste disposal authorities.
The separate collection and recycling
of such products will help protect the
environment and human health.
See also end-of-life information at
www.grundfos.com/product-recycling.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cim 040 ttl

Table of Contents