English (GB) Installation and operating instructions
Original installation and operating instructions
Table of contents
1.
1.1
2.
3.
3.1
3.2
3.3
LED . . . . . . . . . . . . . . . . . . . . . . 5
4.
4.1
4.2
5.
5.1
5.2
6.
7.
8.
1. General information
Read this document before you install the
product. Installation and operation must
comply with local regulations and accepted
codes of good practice.
1.1 Symbols used in this document
Warning
If these safety instructions are not ob-
served, it may result in personal injury.
Warning
If these instructions are not observed, it
may lead to electric shock with consequent
risk of serious personal injury or death.
If these safety instructions are not ob-
served, it may result in malfunction or
Caution
damage to the equipment.
Notes or instructions that make the job
Note
easier and ensure safe operation.
4
2. Abbreviations
CIM
Communication interface module
CIU
Communication interface unit
CU
Control unit
GND
Earth connection
Global system for mobile communica-
GSM
tions
LED
Light-emitting diode
SEG
Sewage grinder pump
SELV
Separated or safety extra-low voltage
SMA
Subminiature version A
TTL
Transistor to transistor logic
3. Product description
3.1 Introduction
The CIM 060 is an add-on module which you can
install in a CIU 902 SEG AUTO
unit or a CU 362 Dedicated Controls system to
enable radio communication with the Grundfos GO.
The on-board antenna enables connection to
Grundfos GO within a 10 meters radius. You can fit
an external antenna for a larger communication
range.
You can establish connection via a button on the
module or via a configurable connection code.
communication
ADAPT