Philio PAT15 Quick Start Manual page 4

3. IDs are excluded and all settings will reset to
factory default.
1. Product has a DSK string, you can key in first five
digit to increment SmartStart process, or you can
scan QR code.
Ex : mydsk
10209-46687-52248-13629-04783-07465-15776-56519
2. SmartStart enabled products can be added into a Z-
SmartStart
Wave network by scanning the Z-Wave QR Code
present on the product providing SmartStart
inclusion. No further action is required and the
SmartStart product will be added automatically
within 10 minutes of minutes On in the network
vicinity.
＊notice1:The QR code can be found on the device
PAT15 or on the box.
This machine provides two groups of nodes.
Group 1 can set 1 Nodes.
Group 2 can set 5 Nodes.
Group 1 is called Lifeline the device will report :
1.Notification report
Association
2.Device Reset Locally Notification
3.Battery Report
4.Indicator Report
Group 2 is called Basic set the device will report :
1.Basic Set
Failed or success in add/remove the node ID can be viewed
•
from Z-Wave TM Controller.
Notice 1: Always RESET a Z-Wave
Z-Wave TM network
Z-Wave TM Notification
After the device adding to the network, it will wake-up once per day in
default. When it wake-up it will broadcast the "Wake Up Notification"
message to the network, and wake-up 10 seconds for receive the
setting commands.
The wake-up interval minimum setting is 30 minutes, and maximum
setting is 120 hours. And the interval step is 30 minutes.
Press the tamper key once. The device will wake-up 10 seconds.
Z-Wave TM Message Report
In default the device will using Notification Report to represent the
tamper trigger and flood trigger event.
＊ Flood Report:
When the flood triggered, the device will unsolicited to send the report
to the nodes in the group 1.
Notification Report (V8)
Notification Type: Water Alarm (0x05)
Event: Water Leak detected, Unknown Location (0x02)
4
TM device before trying to add it to a