Titan T9200 User Manual page 37

TO REPLACE BELT
NOTE: To use replacement belt, see part number detail in REPLACEMENT PARTS (page
7).
1. Install the new belt over the motor drive, then over the belt path.
2. Install the belt side of the agitator back into the base. Replace the end cap into position
and then press down firmly as shown until it is locked into place.
3. Install the non-belt side of the agitator. Replace the end cap into position and then press
down as shown until it is locked into place.
4. Re-fit the two felt washers at the handle in correct positions as shown before re-installing
the middle cover.
Belt
Belt Path
Felt
Washers
-37-
Motor Drive