Table of Contents
Advertisement
4.
Fit the cylinder brackets. Note: There are two different brackets: a right-hand and a left-
hand bracket. The straight side of the bracket should be turned towards the three-point
attachment. Raise the side sections to give you access to fit the bolts under the frame of
the grassland harrow. Tighten all bolts.
5.
Mount the hydraulic hoses (2) on the cylinder and tighten the connections. Do not tight-
en too hard, or the connections will break. Pull out the cylinder rod and then mount the
cylinder on the cylinder brackets. Secure with pins. Check that all bolts are tightened.
Ready for use!
Table of contents
13
Advertisement
Table of Contents
