Install The Remote Switch (Optional); Prime With Material - Graco ToughTek S340e Operation, Repair, And Parts

Install the the Remote Remote Switch
Install Install the Remote
The remote switch is an additional accessory kit and
does not come with models 25A300 and 25A304.
The kit part number is 17G554. See manual 3A3112
for remote switch installation and replacement.
NOTE: NOTE: Use zip-tie (Z) to install the remote switch NOTE:
to the hose or pole spray applicator (follow the
illustrations below). The remote switch will fit on
hoses/applicators sized .75 in. up to 1.25 in.
3A3437F
All manuals and user guides at all-guides.com
Switch (Optional) (Optional)
Switch (Optional)
Component Identification
Prime with Prime Prime with Material with Material Material
NOTICE NOTICE NOTICE
Loading material into a dry system will cause the material
to stick to internal components and cure, causing
damage and requiring replacement of those parts. To
prevent material curing in system, never load material
into a dry system.
The applicator must be removed before priming.
Always push out any remaining water into a waste
container before circulating material. Always circulate
clean material back into the hopper for several cycles
before beginning to spray.
1. Prime the system with water. See
Prime with Water, page
2. Mix the material. See
3. Turn the flow adjustment knob (H)
counterclockwise until it stops.
4. Remove the applicator.
5. Fill the clean hopper with material to be sprayed.
6. Place the hose outlet in a waste container.
7. Turn the motor power switch (S) to ON.
8. Turn the flow adjustment knob (H) clockwise
slowly to increase pressure until water is purged
out and a steady stream of material flows from
the applicator.
NOTICE NOTICE NOTICE
To prevent damage to pump seals caused by
cavitation, run the pump slowly until the system is
primed.
9. To stop dispensing, turn adjustment knob (H)
counterclockwise until it stops.
10. Install applicator.
NOTE: For EIFS finish coats, before installing the
NOTE: NOTE:
applicator, prime the larger ID hose, then install
and prime the transition fitting and whip hose.
11. Recirculate several cycles of material to make
sure the material is flowing properly.
12. Turn the flow adjustment knob (H)
counterclockwise to stop the pump.
13. Install the air line and a tip onto the applicator
(see applicator manual). The system is now
primed and ready to spray.
16.
Mix the Material, page 17.
11