Turning The Ups On And Off; Forcing The Ups To Shut Down - Powerware BD User Manual

Turning the UPS On and Off

The ConnectUPS Web/SNMP Card supports the ability to
remotely turn off the UPS and its supported load. It also
supports the ability to reboot the UPS (cycling output power
off and then back on), as well as the ability to schedule
shutdowns and startups on a predetermined basis.
Selecting
Control
provides a page that allows the Superuser to turn off the UPS.
In addition, you may initiate a battery test and enable or
disable any scheduled shutdowns or startups as specified in the
UPS shutdown schedule table (accessed from the
Configuration menu).
Selecting Turn UPS Off turns off the output of the UPS. Any equipment
powered by the UPS shuts down. Prepare the protected equipment for
the shutdown.
If you select Turn UPS Off with Load Segment to Restart following
the Return of AC Power
the UPS after the shutdown occurs.

Forcing the UPS to Shut Down

1. Select
home page, then
2. Log in as a Superuser.
3. Select
4. Verify
set to
5. Set the appropriate
following the start of the Client's OS Shutdown
to ensure that any NetWatch clients and their
respective operating systems have enough time to
complete their shutdown. The default is 180 seconds,
but you may wish to increase or decrease this value as
appropriate for your system.
ConnectUPS Web/SNMP Card (X and BD Models) User's Guide
UPS Power Management
from the menu at the top of the home page
C A U T I O N
set to NO , you will have to manually restart
from the menu at the top of the
Configuration
UPS Event Actions
UPS Shutdown and Restart Settings
Load Segment to Turn Off following OS Shutdown
.
YES
Delay Before Segment Turns Off
Rev A www.powerware.com
.
.
is
in seconds
23