Led Description; Configuration; Configuring The Card Locally - Powerware BD User Manual

LED Description

The functions of the ConnectUPS Web/SNMP Card are
indicated by the Status and either the 10 Mb or 100 Mb LEDs,
as listed in Table 1.
Table 1. LED Definitions
Status LED
Flickering
On
Off
Flashing

Configuration

You must configure the ConnectUPS Web/SNMP Card before
you can use it. There are two ways to configure the card:
: locally through the serial communication port
: remotely using a Web browser or Telnet utility

Configuring the Card Locally

The card has a configuration program that you can access by
using the supplied serial cable to connect the card to a terminal
or a computer with a terminal emulation program.
If you choose to configure your card locally, see "Local
Configuration" on page 9.
ConnectUPS Web/SNMP Card (X and BD Models) User's Guide
10 Mb or Card Function Description
100 Mb LED
On/Flickering Normal operation with Ethernet traffic
On ConnectUPS Web/SNMP Card error
Off UPS power low (no power to the
ConnectUPS Web/SNMP Card)
Flashing No connection to UPS (alternate flashing as
the ConnectUPS Web/SNMP Card restarts)
:
Rev A www.powerware.com
Installation
7