Local Configuration; Before You Start; Connecting The Card - Powerware BD User Manual

C H A P T E R 3
L C
OCAL ONFIGURATION
Use the following procedure to access the card's configuration
program through a serial port.

Before You Start

To use the configuration program for the card, you need:
: The serial cable included with the card.
: A terminal with a serial communication port, or a computer
with a terminal emulation program such as HyperTerminal
The serial line should be set to 9600 baud, No parity, 8 data
bits, 1 stop bit, and no flow control.

Connecting the Card

To connect the card to the terminal or computer and start the
configuration program:
1. Plug the serial cable into the COM port on the
ConnectUPS Web/SNMP Card.
2. Plug the other end of the serial cable into the TTY
port on the terminal or the COM port on your
computer.
ConnectUPS
Web/SNMP Card
ConnectUPS Web/SNMP Card (X and BD Models) User's Guide
Serial Cable
Figure 4. Cable Connection from Serial Port
:
Rev A www.powerware.com
.
To TTY port on terminal
or COM port on computer
9