Remote Configuration; Add A Routing Condition In The Computer - Powerware BD User Manual

C H A P T E R 4
R C
EMOTE ONFIGURATION
Use the following procedure to access the card's configuration
program through a Web browser.
NOTE Verify that an active 10/100BaseT cable is connected to the card's
network connector (the Uplink Ethernet connector on the ConnectUPS-X).

Add a Routing Condition in the Computer

If the IP address of the computer is on the same network with
the ConnectUPS Web/SNMP Card, you may just run the Web
browser directly.
If the IP address of the computer is not on the same network
with the ConnectUPS Web/SNMP Card (only required while
configuring the card), you can use the Add Routing command.
1. Turn on the computer and set up the TCP/IP protocol
if needed.
2. Enter the following command to add a routing
condition:
Route add 192.168.7.18 192.72.173.20
where 192.168.7.18 is the default IP address of the
card and 192.72.173.20 is an example IP address for
the computer.
NOTE Refer to your operating system documentation for additional details
on how to add a routing condition.
ConnectUPS Web/SNMP Card (X and BD Models) User's Guide
:
Rev A www.powerware.com
17