E-Wheels EW-46 Service & Repair Manual page 35

Wire Harness and Brake Cable Replacement
Wire Harness - The wire harness runs the length of the machine, from front to back. Replacing the wire
will require removing the seat, storage box underneath
the seat, main body shroud, headlight body panel,
and front sliding plate.
Running the replacement harness next to the
previous harness is recommended to avoid
mismatching the wire harness connectors. As you
unplug one connection from the old harness, plug
the connector immediately into the new harness's
identical connector to avoid confusion.
Once all connections have been replaced, remove
the old wire harness and the entirety its mounts. Zip
tie the new harness to the frame at the same points
the old harness was mounted. Test that all functions
of the scooter are working as they should prior to
reinstalling the body paneling.
Front Brake Cable - Removing the headlight body
panel will be necessary to replace the front brake
cable. Once done, the brake handle cable mount
will be exposed. Before you remove the cable from
the handle, first remove the adjusting nut, spring,
and mounting spacer.
Once the brake cable hardware is removed, the
brake line will have no tension. Remove the cable
from the brake handle next by turning the barrel
35