AEG BSE577221M User Manual page 12

Do not put food in the oven
when the Fast heat up operates.
1. Turn the knob for the oven functions to
set the fast heat up.
2. Turn the knob for the temperature to set
the temperature.
The signal sounds when the oven is at the
set temperature.
3. Set an oven function.
7.3 Heat-up indicator
When the oven function operates, the bars in
the display appear one by one when the
temperature in the oven increases, and
disappear when it decreases.
7.4 Steam Cooking
Use only water. Do not use
filtered (demineralised) or
distilled water. Do not use other
liquids. Do not put flammable or
alcoholic liquids into the water
drawer.
1. Set the function
2. Press the cover of the water drawer to
open it.
3. Fill the water drawer with water until the
display shows Tank Full indicator.
The maximum capacity of the tank is 900
ml. It is sufficient for approximately 55 -
60 minutes of cooking.
4. Push the water drawer to its initial
position.
5. Set the temperature between 130 °C and
230 °C.
Steam cooking gives good results with
this temperature range.
6. Empty the water tank after the steam
cooking is completed.
Wait for at least 60 minutes after each use of
the steam function to prevent hot water from
exiting the water outlet valve.
CAUTION!
The appliance is hot. There is a
risk of burns. Be careful when
you empty the water drawer.
12 ENGLISH
.
7.5 Water tank indicator
If you put too much water into the tank, the
safety outlet moves the excess water to the
bottom of the cavity. Remove the water with
a sponge.
7.6 Emptying the water tank
CAUTION!
Make sure that the oven is cold
before you start to empty the
water tank.
1. Prepare the draining pipe (C), included in
the package with the user manual. Put
the connector (B) onto one of the ends of
the draining pipe.
2. Put the second end of the draining pipe
(C) into a container. Put it at a lower
position than the outlet valve (A).
A
B
C
3. Open the oven door and put the
connector (B) into the outlet valve (A).
4. Push the connector again and again to
empty the water tank.
The tank is full. When
the tank is full the sig‐
nal sounds. Press any
button to stop the sig‐
nal.
The tank is half full.
The tank is empty.
When the tank is emp‐
ty the signal sounds.
Refill the tank.