Table of Contents
Advertisement
7.2.10 Passive Program EQ 无源程序均衡器
1. On/Off. Turns the EQ on or off in the signal chain.
2. Low Boost. Sets the level of boost applied around the chosen low frequency. This control interacts
nicely with the Low Attenuation control, allowing for boosts in apparent bass energy while keeping
overall bass energy within optimal limits.
3. Low Attenuation. Sets the level of attenuation applied around the chosen low frequency. his control
interacts nicely with the Low Boost control, allowing for boosts in apparent bass energy while keeping
overall bass energy within optimal limits.
4. Low Frequency Select. Sets the center frequency of the band covered by the Low Boost and Low
Attenuation controls.
5. High Bandwidth. Sets the Q (or width) of the effect of the high EQ band.
6. High Boost. Sets the level of boost applied around the chosen high frequency.
7. High Attenuation. Sets the amount of attenuation applied in a shelving fashion to frequencies at and
above the chosen high frequency.
8. High Frequency. Sets the center frequency of the high EQ band.
9. Attenuation Select. Sets the frequency at and above which the High Attenuation control attenuates
treble content.
1. 开/关。在信号链中打开或关闭EQ。
2. 低频提升。设定所选择的低频周围的提升水平。这个控制与衰减控制有很好的相互作用，允许提升明显的
低音能量，同时将整体的低音能量保持在最佳范围内。
3. Low Attenuation. 这个控制与低速提升控制有很好的相互作用，可以提升明显的低音能量，同时将整体的低
音能量保持在最佳限度内。
4. 低频选择。设置低速提升和低速衰减控制所覆盖的频带的中心频率。
5. 高带宽。设定高 EQ 频段效果的 Q 值（或宽度）。
6. High Boost（高提升）。设定所选择的高频周围的提升水平。
7. High Attenuation（高衰减）。设定在选定的高频及以上的频率上以搁置方式应用的衰减量。
8. 高频。设置高频均衡带的中心频率。
9. Attenuation Select（选择衰减）。设定高频衰减控制，对高音内容进行频率衰减。
7.2.10 Passive Program EQ
76
Advertisement
Table of Contents
