Table of Contents
Advertisement
预置。在小、中、大之间进行选择。这些预置模拟了房间的大小。一般来说，房间尺寸越大，混响就越
大。
尺寸。这个设置可以调整每个反射声的长度，以及你听到它们的频率。
HPF（高通滤波器）。像 Fat Channel 中的High Pass Filter（高通滤波器）一样，这个设置将削减混响
输出中低于你在这里设置的阈值的频率。
Power User Tip: This is especially helpful for bass-rich sound sources (baritone voice, acoustic guitar)
as adding too much reverb in low frequencies can muddy your sound.
用户提示：这对富含低音的音源（男中音、原声吉他）特别有帮助，因为在低频添加过多的混响会使
你的声音变得混浊。
Pre-Delay. Pre-Delay is the time (in milliseconds) between the end of the initial sound and the
moment when the first reflections become audible.
预延时。预延迟是指从最初的声音结束到第一个反射时可听得见的时间（以毫秒计）。
Power User Tip: Imagine you're on a stage in a large music hall. You stand on the very edge of the
stage and shout "Hello world!" toward the center of the hall. There will be a brief pause before you hear
the first noticeable reflections of your voice, because the sound waves can travel much further before
encountering a surface and bouncing back. Adjusting the pre-delay parameter on a reverb allows you to
change the apparent size of the room without having to change the overall Size. This will give your mix a
little more transparency by leaving some space between the original sound and its reverb.
用户提示：想象一下，你在一个大型音乐厅的舞台上。你站在舞台的最边缘，朝大厅的中心大喊 " 世界
你好！ " 。在你听到你的声音的第一个明显的反射之前，会有一个短暂的停顿，因为声波在遇到表面和
反弹之前可以走得更远。调整混响器上的预延时参数可以让你改变房间的表面大小，而不必改变整体尺
寸。这将使你的混音更有透明度，在原始声音和它的混响之间留下一些空间。
Reverb (Amount). To change the amount of Reverb affecting Channels 1 and 2, use the Reverb con-
trol at the top of either Channel to dial in the amount to taste.
混响（量）。要改变影响Channel 1和2 的混响量，可以使用任一 Channel 顶部的混响调节器来拨动
量。
5.1 Fat Channel and Voice FX
63
Advertisement
Table of Contents
