Mixer Controls 混音器控制; Microphone Channel Controls 麦克风通道控制; Mixer Channel Controls 混音通道控制 - PRESONUS Revelator io44 Owner's Manual

6.1 Mixer Controls 混频器控制
6.1.1 Microphone Channel Controls 麦克风通道控制
6.1 Mixer Controls
1. +48v. Engages/disengages +48v power for use with condenser
microphones like the PreSonus PX-1 or M7.
2. Gain. Use this control to set the gain for your connected micro-
phone or instrument. Gain can also be set using the Encoder
knob on your Revelator io44.
3. Reverb. Use this control to set the amount of Reverb applied to
the signal. Reverb settings can be set up to taste using the
Reverb section. See the
for more on Reverb.
4. Pan. This sets the pan position for your signal in every stereo
mix. Pan sets the position of the microphone relative to the left
and right side of the mix. When the Pan is set to the center pos-
ition, your microphone will sound equally in both the left and right
side of the mix. As you turn it to the right, it will be louder in the
right side. As you turn it to the left, it will be louder in the left side.
5. Clip Light. This light will illuminate red when the input signal is
too loud and clipping. If your input signal clips, it will overload the
Revelator io44's analog-to-digital converters, causing digital dis-
tortion. This sounds terrible. If you record a signal with digital dis-
tortion, there is no undoing it or fixing it. And because of this, it's
important to keep your eye on this indicator while you're setting
your levels.
1. +48v. 启用/关闭+48v电源，用于电容式麦克风，如PreSonus PX-
1或M7。
2. 增益。使用这个控制为你所连接的微型电话或乐器设置增益。增
益也可以用Revelator io44上的编码器旋钮来设置。
3. 混响。使用这个控制器来设置应用于信号的混响量。混响的设置
可以用混响部分来设置。关于混响的更多内容，请看Fat Channel和
声音效果部分。
4. 平移。这是为你的信号在每个立体声混音中设置平移位置。泛音
设置了麦克风相对于混音的左右两边的位置。当泛音设置为中心位
置时，你的麦克风将在混音的左边和右边发出同样的声音。当你把
它转到右边时，它在右边的声音会更大。当你把它转到左边时，它
在左边的声音会更大。
5. 剪辑灯。当输入信号太大，并出现削波时，这个灯会亮起红色。
如果你的输入信号被剪辑，它将使 Revelator io44 的模数转换器过
载，导致数字中断。这听起来很糟糕。如果你录制的信号有数字失
调，就无法撤销或修复它。正因为如此，当你设置电平时，一定要
注意这个指标。
Fat Channel and Voice Effects section
64