Logon Screen - ADC HiGain H2TU-C-388 List 7F Manual

Provisioning

Logon Screen

The maintenance terminal screens allow you to monitor, provision, and troubleshoot an HDSL2 system.
To select a menu from the logon screen shown in
• Press the underlined letter of the menu.
← →
•
Use the arrow keys to select the menu, then press
Table 3 below summarizes the navigational keys. They are also listed in the onscreen Help menu.
page 11 describes the logon screen menus.
Most VT100 emulation programs support a print screen option. For Windows-based programs,
such as Procomm or HyperTerminal, see the Help menu for instructions.
Table 3. Navigational Keys for the Maintenance Terminal Screens
(a)
Key
SPACEBAR
ENTER
ESC F11
or (VT100 only)
CTRL E
↑ or +
↓ or CTRL + X
→
or CTRL + D
←
or CTRL + S
CTRL R
+
(a) Legacy management units require use of control keys instead of arrow keys.
10
Function
Cycle through selections.
Activate the current setting or choice, or display a menu.
Return to the parent menu.
Select the submenu or item above the current one, or return to the previous menu.
Select the submenu or item below the current one.
Select the menu or item to the right of the current one.
Select the menu or item to the left of the current one, or return to the previous menu.
Refresh the screen.
Menu bar
Circuit ID Date and Time
Figure 3. Logon Screen
July 21, 2003
Figure 3, do one of the following:
ENTER
.
Logon Device
LTPH-UM-1214-02
Table 4 on
System Status
H2TU-C-388 List 7F