ADC HiGain H2TU-C-388 List 7F Manual page 24

Provisioning
• Date and time (see
• Master clear (see
• Reset to factory default configuration (see
Most configuration options can also be set from a network test center through TL1 commands
embedded in the FDL ESF framed payload (intrusive) or in the payload itself with 11-bit
commands (intrusive).
To obtain additional information about remote provisioning commands, contact customer
service. See
Making Changes to Standard and ADC Options
Figure 7 on this page and
options are those supported by HiGain HDSL2 units when connected to units from other vendors. ADC options
are an extended set of options that are only available when using HiGain units exclusively. For a description of
each option and a list of option settings, refer to
To make changes to these options:
1 Press C to select the Config menu.
2 Use the and
↑ ↓
3 Use the arrow keys to select an option.
SPACEBAR
4 Press
5 Press ENTER to activate your choice.
14
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
"Resetting to Factory Defaults" on page
"Appendix D - Product Support" on page
Figure 8 on page 15 show the Standard and ADC configuration options. Standard
arrow keys to select Standard Options or ADC Options, then press
to cycle through the settings for that option.
Figure 7. Config Menu - Standard Options (defaults shown)
12).
68.
Table 5 on page 16 and Table 6 on page
July 21, 2003
LTPH-UM-1214-02
24).
24).
17.
ENTER .
H2TU-C-388 List 7F