Advertisement
O P E R A T I O N
The ADJ UVLED 24 contains an automatic voltage switch, which will automatically sense the voltage
when it is plugged into the power source. With the automatic voltage switch, you do not need to worry
about wall voltage, and this unit can be plugged in almost anywhere. This fixture is designed to oper-
ate as a stand alone unit, and there is no need for a controller. It has been tested thoroughly, and no
assembly is necessary. Remove the fixture from its box, plug it into a matching power outlet or into a
power pack, and just "flip" the power switch on. The fixture will illuminate immediately when powered
on.
C L E A N I N G
Due to fog residue, smoke, and dust, cleaning the external housing and lens should be carried out
periodically to optimize light output. Cleaning frequency depends on the environment in which the fix-
ture operates (I.e. smoke, fog residue, dust, dew). In heavy club use, it is recommended to clean the
fixture on a monthly basis. Periodic cleaning will ensure longevity and crisp output.
•
Using a soft cloth, care fully wipe down the outside case and gently wipe down the lens.
T R O U B L E S H O O T I N G
Common problems and possible solutions listed below.
NO Light Output from Fixture:
•
Check power switch is in the ON position.
•
Check that the fixture is receiving power.
•
Check whether the circuit breaker for the power outlet the fixture is plugged into has been tripped.
•
Contact ADJ Customer Support.
8
Advertisement
