How To Set-Up The Gb745 - Gage Bilt GB745 Instruction Manual

Hide thumbs Also See for GB745:

User manual (13 pages)

Manual (13 pages)

Table Of Contents

Table of Contents

WARNING:

Only qualified and trained operators shall install, adjust or use the assembly power tool for non-threaded

mechanical fasteners.

WARNING:

Operator

WARNING:

It is required that eye protection, hearing protection and safety boots be worn at all times while handling this

equipment.

WARNING:

The users or the user's employer must assess specific risks that could be present as a result after each use

based on their application.

●

Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of any

moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.

● Verify

●

Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool

WARNING:

Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other

persons working in the vicinity, foreign matter and liquid.

WARNING:

Do not carry from hoses or use as a hammer.

WARNING:

Do not use in explosive atmosphere.

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

WARNING:

Ensure there is adequate clearance for tool and operator hands.

WARNING:

Do not operate this tool without deflector, pintail catcher bag or pintail collection bottle in place.

CAUTION:

Do not use beyond the design intent.

The tool is shipped with a red plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept user air

hose fitting. The tool comes with oil and is ready to use.

1. Remove red plastic shipping plug from Swivel (A-249) (air inlet) and screw in your quick disconnect (air) fitting.

2. Attach Deflector (704113) to rear of head cylinder (745366). Rotate deflector (704113) away from operator or other people

working in the vicinity.

3. Connect tool to air hose with 90 psi. (6.2 bar) using clean, dry air. 3/8" (9.52 mm) minimum diameter air line is recommended.

Cycle tool five times by depressing and releasing actuator lever assembly (704343).

4. Disconnect air hose from tool.

5. Select proper nose assembly (see nose assembly selection chart on pg. 19 for more information). Screw collet onto piston and

slide anvil over collet and secure with retaining nut (480124). (See proper data sheet for further instructions).

6. Connect air supply.

USER QUICK

DISCONNECT FITTING

AIR HOSE

GB745 INSTALLATION TOOL S/N: 3569 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.