Installation - EdilKamin FIREBOX DECO Installation, Use And Maintenance Manual

PRODUCT HEIGHT
Be fixed on a support stand option or in a specific
self-made one.
SUPPORT STAND OPTION
(fig. L)
Screw the 2 frame-fastening brackets (A) to the bottom
of the Firebox® structure, using the ø 3.6 holes and
the six 4.8x13 screws provided.
At the pre-cuts, cut the vertical tubes of the support
frame (B) to the desired height for positioning Firebox®.
Using the pins provided, fi t the frame (B) to the
brackets (A) previously fastened to Firebox ®.
Take care that the horizontal projections (C) of the
frame are on the rear facing the wall.
Lock the support stand with the four 8x40 screws
provided.
Position Firebox® with stand and fasten to the fl oor
using the anchors and 8x70 screws provided.

INSTALLATION

FIXATION
Use the screws to fix the product.
NOTE
As far as the EXTERNAL AIR INLET DEVICE is
concerned (code 163750 and 163769), please
remove the pre-cut shown by the red arrow
Do NOT remove metal part shown by the blue arrow
for any reason.
Failure to follow the above instructions
can cause the insert to tip over with
possible serious injury to the user.
9