Table of Contents
Advertisement
Installation
April 2022-
3.4.2
Installation- the Catenary Sag
3.4.3
Installation/Disassembly-Chain
Connect the chain/One piece Chains with Round Pins
Minor or moderate injury will or could occur
The chain should be hand tight when installed. Chain should never be over tensioned.
3.4.4
Connect the chain / One Piece Chains with Style D Pins.
3.4.5
Connect the chain/ One Piece Chains with Knurled Style Pins.
24
The function of the catenary is to allow a place for excess chain to accumulate.
Rex® TableTop® chains should never be run tight.
The catenary sag should be measured when running with product.
If the catenary sag is excessive or increased due to normal wear, it should be
adjusted by removing links to obtain the proper sag.
To connect each 10 ft. section, start by positioning the connecting pin into either
one of the double eyes in the appropriate end link. Position the single eye of the
other end link between the double eyes. Then drive pin through the single eye
and into the adjacent double eye, using a drift punch and hammer, until
connecting pin is centered in the link.
CAUTION
When installing the last section, separate the chain to required length using a drift
punch and hammer to drive appropriate connecting pin out of chain. Make final
connection to complete the chain loop.
To connect each 10 ft. section, start by positioning the connection pin into either
one of the double eyes in the appropriate end link. Take care in positioning the
flat of the pin to match up with the flat on the link hole. Position the single eye of
the other end link between the double eyes. Then drive pin through the single eye
and into the adjacent double eye, using a drift punch and hammer, until
connecting pin is centered in the link. When installing the last section, separate
the chain to required length using a drift punch and hammer to drive appropriate
connecting pin out of chain. Make final connection to complete the chain loop.
To connect each 10 ft. section, start by positioning the connecting pin into the
correct side of the chain.
Always smooth end of pin first. Position the links together then drive pin into the
hinge using a drift punch and hammer until connecting pin is recessed into the
link like adjacent pins.
Reference Manual
00809-200-4245
Rosemount HMC-C01
Advertisement
Table of Contents
