Tensiometer T8
1.2 Content of delivery
The delivery of a T8 includes:
Tensiometer, calibrated and filled, with 8-pin plug M12/IP67, with
plug cap
This manual
Plastic bottle protecting the ceramic cup (must be filled to half
with water to keep the cup wet)
Rubber shaft water protection disk
Calibration certificate with each order for conversion of electrical
to physical values
Refilling syringe
For available accessories see chapter "Accessories".
1.3 Foreword
Measuring systems must be reliable and durable and should require
a minimum of maintenance to achieve target-oriented results and
keep the servicing low. Moreover, the success of any technical
system is directly depending on a correct operation.
At the beginning of a measuring task or research project the target,
all effective values and the surrounding conditions must be defined.
This leads to the demands for the scientific and technical project
management which describes all quality related processes and
decides on the used methods, the technical and measurement tools,
the verification of the results and the modeling.
The continuously optimized correlation of all segments and its quality
assurance are finally decisive for the success of a project.
We wish you good success with your projects. Please do not hesitate
to contact us for further support and information.
Yours,
Georg von Unold
5/58