Table of Contents
Advertisement
T8 configuration with tensioVIEW®
Figure 4.2: Configuration menu
tensioLINK
Bus number
tensioLINK bus number of the device
Sub address
tensioLINK sub address of the device
Explanation:
tensioLINK uses two types of address for each device, the bus
address and the sub address. The reason for this is that is there
might be sensors installed at the same spot, but with different
measuring depths (for example multi-level probes). In this case, the
sub address defines the depth starting with 1 for the highest sensor.
Furthermore, the sub address could be used to combine groups of
sensors, for example of one measuring site.
In general the required identification for a device is always the bus
number. If more than 32 devices are connected to the bus the sub
address is counted up. The allowed numbers for the bus address are
1 to 32 and for the sub address 1 to 8.
28/58
Advertisement
Table of Contents
