Length And Solar Protection Of Refilling Tubes - UMS T8 User Manual

Long-term monitoring tensiometer
Table of Contents

Advertisement

Installation
Lightning: cables act as antennas and should always be as short
as possible.
3.1.4 Protection of refilling tubes
A recent study by Prof. Wolfgang Durner showed that refilling
tubes must be protected from heating up and solar radiation.
If a bubble assembles inside a refilling tube, temperature changes
will lead to an expansion of the air resulting in a variation of the
reading. Therefore, refilling tubes should be as short as possible and
should be thermally protected, either by providing an insulating
protection or by burying the tubes.
Thermal effect:
As long as the Tensiometer and its tubes are freshly and completely
Slide the supplied thermal insulation tube over the shaft end , the
refilling tubes and sensor cable as shown in above photo. Please
keep a distanz of approx. 5 cm to the soil surface to avoid ant
population inside the tube!
filled it will work perfectly. Any air trapped
inside the upper parts of the tube will expand
when heated up by solar energy. This causes
a drop of the water tension and some water
will flow from the cup into the ground.
Thus, readings will fluctuate around the actual
reading during solar radiation, especially with
low water potentials. Furthermore, under
permanent solar exposure the tubes get sticky
and brownish.
17/58

Advertisement

Table of Contents
loading

Table of Contents