Omron SYSMAC CVM1 Series Operation Manual page 66

Replacement Checklists
Item Original Unit: C500-LK009-V1
Level/Link Check setting on pins 3 and 4 of SW3:
Number [
Pins Level/Link Number setting
3 & 4
11 Single-level LK009
10 Single-level LK003
01 Multi-level Link #1
00 Multi-level Link #0
Transmis- Check setting on SW2:
sion Line [ Up (4-wire)
Selector
Up 4-wire/Use optical fiber cable.
Down 2-wire/Use electrical cable.
Terminating Check setting on pin 1 of SW3:
Resistance [ 1(ON
1 Terminator connected.
0 Terminator not connected.
LR Area LR 00 to LR 63
(or LR 00 to LR 31 in the C500)
PC Link Error SR 247 to SR 250
and PLC Run (or SR 58 and SR 62 in the C500)
Flags
Level Flags Level #1
Single-level or level
#0
PC Link Unit Level #1
Restart Bits
Single-level or level
#0
Replacement Unit: CVM1-LK401
Pins 3 and 4: Set the same Level/
] Link Number as set on the C500-
LK009-V1.
Pins
3 & 4
11
10
01
00
WIRE switch: Set the same setting
Down (2-wire)] as set on the C500-LK009-V1.
4 (left)
2 (right) 2-wire/Use electrical
TER switch: Set the same setting
)/ 0 (OFF)] as set on the C500-LK009-V1.
ON
(left)
OFF
(right)
CIO 1000 to CIO 1063
CIO 1500 + 25 × N to
CIO 1500 + 25 × N + 3
AR 2411 Level
#1
(Except C500)
AR 2412 Single-
level or
(Except C500)
level #0
SR 25210 Corresponding bit in A001 (CPU
(SR 6010 in C500) Bus Unit Restart Bits)
SR 25214
(SR 6014 in C500)
Level/Link Number set-
ting
Single-level (Either 11 or
10 can be set.)
Multi-level Link #1
Multi-level Link #0
4-wire/Use optical fiber
cable.
cable.
Terminator connected.
Terminator not con-
nected.
CIO 1500 + 25 × N + 4,
bit 11
CIO 1500 + 25 × N + 4,
bit 12
Section 3-6
Remarks
The CVM1-LK401's sin-
gle-level mode is equiva-
lent to the C500-LK009-
V1's single-level LK009
mode. The CVM1-LK401
cannot emulate the sin-
gle-level LK003 mode.
Pattern A systems do not
include Units set to sin-
gle-level LK003 mode.
---
---
N is the CPU Bus Unit's
unit number.
51