Verizon ARC-XCI55AX User Manual page 44

• Alternatively, you can enter the Gateway's PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
4. After pressing the WPS button on your Gateway, you have
two minutes to press the WPS button on the client device
before the WPS session times out.
When the WPS button on your Gateway is pressed, the
Status LED on the front of your Gateway begins flashing
blue. The flashing continues until WPS pairing to the client
device completes successfully. At this time, the Status LED
turns solid blue.
If WPS fails to establish a connection to a Wi-Fi client device
within two minutes, the Status LED on your Gateway flashes
red for two minutes to indicate the WPS pairing process was
unsuccessful. After flashing red, the light returns to solid
white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
http://support.verizon.com/router
03 / WI-FI SETTINGS
| ©2022 Verizon. All Rights Reserved
44