Verizon ARC-XCI55AX User Manual page 27

4. After pressing the unified button (WPS) on your Gateway,
you have two minutes to press the WPS button on the client
device before the WPS session times out.
When the unified button (WPS) on your Gateway is pressed,
the Status LED on the front of your Gateway begins flashing
blue. The flashing continues until WPS pairing to the client
device completes successfully. At this time, the Status LED
turns solid blue.
If WPS fails to establish a connection to a Wi-Fi client device
within two minutes, the Status LED on your Gateway flashes
red for two minutes to indicate the WPS pairing process was
unsuccessful. After flashing red, the light returns to solid
white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
CONNECTING A WI-FI DEVICE USING A PASSWORD
1. Verify each device that you are connecting with Wi-Fi has
built-in Wi-Fi or an external Wi-Fi adapter.
2. Open the device's Wi-Fi settings application.
3. Select your Verizon Internet Gateway's Wi-Fi network name
(SSID) from the device's list of discovered Wi-Fi networks.
http://support.verizon.com/router
02 / CONFIGURING YOUR
VERIZON INTERNET GATEWAY
| ©2022 Verizon. All Rights Reserved
27