Table of Contents
Advertisement
Anti-tip wheels
The anti-tip wheels are located at the rear of the scooter frame (Fig 8). The scooter should not
be used unless the anti-tipping wheels are in place.
Shoprider® is not responsible for damage or injury incurred due to improper or misuse of the
scooter.
7.
STARTING TO DRIVE YOUR SCOOTER
First Time Use
Prior to using your TE-GK9 Portable scooter for the first time, you must charge the batteries
fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging the
batteries completely prior to first time use will benefit battery efficiency. Failure to do so may
cause permanent damage.
Getting Started
•
Select a level area with plenty of space.
•
Mount the scooter by pushing the arm upward out of the way and sliding onto the seat
or swivel the seat around to mount. Use the arm rest for support if necessary.
•
Adjust the tiller and seat as previously described.
Starting Scooter Movement
•
Ensure that you are seated in a comfortable position.
•
Turn the key to the on position.
•
Your speed setting should be on or near the turtle (slow).
•
Push your right thumb lever (yellow) and the scooter will move forward slowly. The harder
you push, the faster the scooter goes but will only reach the speed level that has been
selected.
•
Release the lever and the scooter will slowly come to a stop as the magnetic brake
automatically engages.
Steering
Steering the scooter is light and easy. When Starting off ensure that you give a wide clearance
when turning so that the rear wheels clear any obstacle that you are passing.
When steering through limited spaces such as a doorway or when turning around, turn the
tiller handles where you want to go and apply power gently. The scooter will turn very tightly,
but will still move with complete stability as long as the speed is not too high.
Reversing
Before reversing ensure that the area behind is free from any hazards or obstructions. Adjust
your speed setting to a low setting before you move in reverse. Push your left thumb lever
(black), and steer wide of all corners and obstacles.
Dismounting
Before dismounting ensure that the key is turned to the off position.
Dismount the scooter by pushing the arm upward out of the way and sliding off the seat or
swivel the seat around to dismount. Use the arm rest for support if necessary.
CAUTION: Please ensure that care is exercised when mounting or dismounting the scooter and
that the tiller and foot rest is not used for support.
6
Shoprider Scooters User Guide
Advertisement
Table of Contents
