FREE WHEEL OPERATION (FIG. 12A & 12B)
The free wheel lever allows you to put the scooter in neutral and push it. The free wheel release
lever is located toward the inside of the rear wheel (Fig. 12A & 12B). To push the scooter
(neutral), push the free wheel lever down. To put the scooter in gear (drive), lift the lever up.
The scooter will not operate when the lever is down (neutral).
WARNING! For safety, always put the scooter into gear (lever up) after pushing or rolling
scooter. Failure to do so may result in injury.
Anti-tip Wheels
The anti-tip wheels are located at the rear of the scooter frame (Sprinter XL4) (Fig. 12B). The
scooter should not be used unless the anti-tipping wheels are in place.
Shoprider® Mobility Products is not responsible for damage or injury incurred due to
improper or misuse of the scooter.
Rear
Chassis
Cover
Freewheel
Release
Lever
Figure 12A
Sprinter Jumbo XL
Getting Started
• You must charge your scooter completely before first time use (8-12 hours).
• Select a level area with plenty of space.
• Mount the scooter, either by lifting the arm and sliding onto the seat or rotate the seat
outwards, mount and then rotate the seat back to face the tiller.
• Adjust the tiller and seat as previously described.
12/29/2004
Circuit
Breaker
Scooter
Serial
Number
STARTING TO DRIVE YOUR SCOOTER
Rear
Chassis
Cover
Anti-tip
Wheels
11
Circuit
Freewheel
Breaker
Release
Lever
Scooter
Serial
Number
Figure 12B
Sprinter XL4