Remote Control Operation; Installing Batteries; Terminal Interface - Tesla 32M320BH Quick Start Manual

REMOTE CONTROL OPERATION

Installing Batteries

1. Slide in the direction shown by the arrow in Image 1 below to open the cover of the batteries on the back of
the remote control.
2. Load two AAA alkaline batteries in the compartment.
3. Replace the cover of the batteries.
Precautions
• Make sure that there is no obstacle bet ween the remote control and television set.
• Keep the remote control away from heat sources and humid areas to ensure effective performance of the remote
control.
• As strong light may interfere with the signals, change your position to operate the remote control if the television
cannot be turned on or off as you excpect.
• Make sure that two AAA 1.5V alkaline batteries are loaded correctly.

TERMINAL INTERFACE

AV input
External AV Signal Input And
Relevant Right/Left Sound Channel
AV output
TV AV Signal output And Relevant
Right/Left Sound Channel (Some
models without this interface)
Y Pb Pr input
Connect to the composite terminal
of yourDV D/VCR (Some models
without this interface)
HDMI input
Digital signal input from HDMI
video connector.
ANT75
Connect the antennal/cadle tv input
(75NHF/UHF)
VGA input
PC analog signal input
PC AUDIO INPUT
VGA input and audio input when
VGA input
EARPHONE output
When earphones are plugged in,
speakers are disabled (Some
models without this interface)
USB input
Connect a USB device here
to play its media files
COAXIAL
Connect the SPDIF receiver. (Some
models without this interface)
SCART input
Standard, it supports composite
and RGB signal input.It is a
connection for european (Some
models without this interface)
Cl
Connect the Data TV decryption
card
5
ENG