REMOTE CONTROL INSTRUCTIONS
Inserting Batteries in the Remote
1. Remove the battery compartment cover from the back of the remote control by lifting the cover.
2. Insert 2AAA batteries. making sure the polarities(+and-) are aligned correctly.
3. Put the cover back.
If the remote control does not work, check these points:
• Are the polarities (+, -) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cord plugged in?
• Is there any interference or block near the remote control sensor?
CAUTION:
• Used batteries should be recycled.
• Keep out of children's reach.
• DO NOT use new and old batteries together.
• Change both the batteries at the same time.
• When not using the remote control for a long time, remove the batteries from the unit.
Warning: All batteries (packed or in use) must not be exposed to high temperature like sun heat or fire.
Remote Control Reception Angle
Use your remote control within the distance and angle range shown below.
Remote Control Sensor
9
ENG