Mounting - Goodwe ET Series User Manual

Installation Instructions
Mounting Support Requirements
• The mounting support shall be nonflammable and fireproof.
• Make sure that the support surface is solid enough to bear the product weight load.
• Do not install the product on the support with poor sound insulation to avoid the noise
generated by the working product, which may annoy the residents nearby.

2.3.2 Mounting

The inverter must not be installed near flammable or explosive materials or near
equipment with strong electromagnetism.
The inverter is suitable for mounting on concrete or other non-combustible surfaces only.
1
Please use the mounting bracket as a template to drill 4 holes in the correct
positions (e.g. 10mm in diameter and 80mm in depth).
Use the expansion bolts in the accessory box and tightly attach the mounting
bracket to the wall.
Note: The bearing capacity of the wall must be greater than 25kg. Otherwise, the wall
may not be able to prevent the inverter from dropping.
110mm
2
Carry the inverter by holding the heat sink on two sides and place the inverter on
the mounting bracket.
120mm
120mm
self-tapping screws
User Manual V1.2-2022-03-30
wall bracket
expansion pipe
8