dynabook Satellite C40-J Hardware Overview page 62

3 Diagnostic Programs
IP Address cannot be acquired
No Intel PRO Set found
No executable file
Device not connected
Device has a problem
This Device is disabled
This Device is currently stopped
Space Size Error
No par��on or file
Item not support this device
�
Test result ... The test results to be shown on the screen are as follows:
Result
--
OK
NG
�
PASS ... Shows the current PASS count for the test.
3-3-4 Test Procedure
This sec�on describes the general procedure for execu�ng the test items.
1) Select the test items to run from Test Item and check it.
If you check or un-check "Check all Items", you can select or deselect the all test items. 2)
Set the LOOP count, and check or un-check Mul�task and CPU Stress for the Aging tests. 4)
Click the [START] button and the test starts.
5) If Mul�task is checked, a�er all Non Aging tests are done, Aging tests you selected will run simultaneously.
6) If each test's pass count reaches the "LOOP count" you set or if the [STOP] bu�on is clicked, the test will terminate.
3-10
The IP address is not able to be
obtained. The LAN cable may not be
connected.
For WIRELESS LAN test, Intel Pro Set u�lity is necessary to be
installed in the system.
The program file (executable file) for the test is missing.
The device necessary for the test is not connected/existed
(YangPass40
item since this machine has no these devices).
Some failure occurred in the device driver.
The device has been removed.
The device is in the STOPPED state.
There is not enough space for test in the test device
There is no par��on in HDD (includes SSD/eMMC) or USB/SD
storage, or no file exists in HDD (includes SSD/eMMC) storage.
The test item not support this device.
Explana�on
This means that the test has not started yet or the test has been skipped.
The test was successful
The test failed
Maintenance Manual
will have this status for ODD, FDD and 1394 STORAGE test
SATELLITE PRO C40-J/C50-J