Redundant Iptv Input; Rf Output - axing MIE 8-00 Manual

2.5.

Redundant IPTV input

The CAS interface can be used as a redundant IPTV input. If there are no more input transport streams at the IPTV input for a
certain time, the MIE switches to the redundant input. The MIE then obtains its inbound transport streams from this interface.
When the input transport streams are again present at the IPTV input, the MIE automatically switches back to the IPTV input. This
switching back usually takes a little more than a minute.
2.6.

RF output

Each module of the MIE has its own RF output.
 The DVB-C/T distribution network must be installed and connected to the equipotential bonding according to EN 60728-11.
 Connect the output (RF OUT) of the device to the established distribution network. Use a high-shielded coaxial cable with an
F connector.
 If you are using a MIE with more then one module or several MIE, then the outputs must be connected to suitable combiners.
 There has to be used galvanic isolator between the output connector and antenna network in Sweden and Norway state area.
2022-05-31 | Technical improvements, changes in design, printing- and other errors reserved. | BA_MIE.pdf | Page 13 of 68