Cas Simulcrypt (With Mks 1-02); Global Settings; Cas List - axing MIE 8-00 Manual

4.10. CAS Simulcrypt (with MKS 1-02)

The setup for the conditional access system requires the installation and configuration of a CAS server, which generates ECMs and
EMMs, among other things. Setting up a CAS server is not described in this document.
To configure the settings for the headend unit, you must have a corresponding licence (see 3.8 on page 51). If this licence is
activated in the headend, the necessary settings can be made under CAS.
 Click on CAS SETTINGS.
Several fields and tables for the CAS settings are displayed.

4.10.1. Global Settings

Enable Simulcrypt: Enable or disable Simulcrypt (license needed to activate).
Network interface used for all simulcrypt-related network traffic, option values:
•
Control (Configuration port)
•
IPTV (IPTV input)
•
CAS (CAS port)
The IP address of the port must be configured for EMMG (CAS server), see 3.7.3 on page 45.
EMMG Listening Port: TCP port configured in EMMG (CAS server) to connect the headend.

4.10.2. CAS List

The table is used to assign readable names to CAS-IDs in order to be able to assign them more easily in the following tables.
Add here all connected CA-Systems. Each CA-System is identified by two IDs, the "CA system id" (CAS ID) and "CA subsystem id"
(Sub ID) 3 .
3 Sometimes both values can be seen combined to a single "Super CAS ID".
2022-05-31 | Technical improvements, changes in design, printing- and other errors reserved. | BA_MIE.pdf | Page 53 of 68